![]() ![]() "Sketch contains conflicting constraints (click to select) Please remove at least one of the following constraints. "Cannot set the datum because the sketch contains conflicting constraints." "Redundant" means that one of the constraints can be derived from the others.Īt other times I've had it tell me constraints were contradictory: "Unsolved" means that your constraints are contradictory. Try to set the length constraint to "-Dim.Base_OD/2"īug_Sketcher_ConstrainTriangle_2.FCStd (21.49 KiB) Downloaded 21 times You get an error saying the constraint can't be negative With the file Bug_Sketcher_ConstrainTriangle_2.FCStd: I have attached another file, the original source of the issue. I am assuming that is how the above "unsolved" problem comes about. But the constraints allow for another positioning. Can you explain how to do that?įor me, it works as expected - meaning, when the sketch is fully constrained, it's impossible to move any geometry. I simply cannot figure out how to flip it after it's fully constrained. The constraint should be legal (it is legal/permitted to set a horizontal distance constraint negative), but it will suffer from the same problem as the other two.īug_Sketcher_ConstrainTriangle_1.FCStd (9.26 KiB) Downloaded 30 times ![]() If you attempt to set the distance from the side parallel to the Y-axis to the origin to a negative value, you get an error, "Negative datum values are not valid for the constraint with index 10". It is not you can flip it parallel to the Y-axis about the point used in the constraint and still meet the constraints. Then the sketch is considered fully constrained. The center of the triangle to the Y-axis, ![]() The attached sketch is reported as having 1 degree of freedom left. I've come across a situation where Sketcher claims a triangle is fully constrained when it is not.Īs nearly as I can tell, this is an unreported bug. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |